Mitermatepro™ Miter Saw Stand - Setup

1. Locate your Mitermatepro™ in a convenient location:
   • Where there is ample clear, safe work area
   • Near the work site and your materials (lumber, siding, etc)
   • Within reach of adequate power for your tools
2. Place and Orient the Mitermatepro™ where you want it set up
3. Stand it on end and balance it with your right hand
4. With your left hand, grasp the outrigger support just below the release
5. While using your thumb to press the release pull out the outrigger supports one at a time and set them aside
6. Also release the legs on this end and fully extend them
7. Set the unit down on the extended legs and move around to the wheeled end
8. Release the legs on the wheeled end
9. Lift the wheeled end and fully extend these legs
10. Check the unit for level and stability
11. Lean a plank on the saw stand clamping bar
12. Lift the end of the plank and place an outrigger support about 3/4 of the way along the plank
13. Snug the clamps on the outrigger (try to keep a 1/4" gap between the plank and the bar)
14. Align the plank with the saw fence (horizontally and vertically)
15. Snug the clamps on the saw stand (try to keep a 1/4" gap between the plank and the bar)
16. Lean a second plank onto the clamping bar on the other side of the stand
17. Lift this plank and place the remaining outrigger support about 3/4 of the way along the plank
18. Snug the clamps on the outrigger (try to keep a 1/4" gap between the plank and the bar)
19. Align the plank with the saw fence (horizontally and vertically)
20. Snug the clamps on the saw stand (try to keep a 1/4" gap between the plank and the bar)