Mitermatepro™ Miter Saw Stand - Repetitive Cuts

  1. Tap a nail into the plank

    2. If you have hammer and nail always handy, measure the required length and tap in a nail. Snug subsequent boards up to the nail and make your cuts.
  2. Clamp a block on the extension plank

    3. Clamps are extreamly handy with the Mitermatepro™. Just measure the required length and clamp a block onto the plank. Snug subsequent boards up to the block and make your cuts.
  3. Make a pencil mark on the plank or the fence

    4. Measure the required length and make a mark on the plank or the fence. You can even write a note on the plank to refer to this mark later (eg. Door header).