Mitermatepro™ Miter Saw Stand - Leveling

1. Set up the stand and check for front to back level, the side to side level is not critical. If you are on sloping ground the whole workstation can slope from side to side but must be level front to back
2. Check the working height (if you are going to adjust it, should it be lower or higher?)
3. When you have determined that one side needs to be raised or lowered, take the weight off the leg you are going to adjust by tipping the unit with you shoulder, loosen the locking skrew, adjust the leg length, re-tighten the locking skrew, and check the adjusted height
4. Repeat on the other legs as necessary
5. Adjust the outrigger support legs for elevation to match the slope of the saw deck and then adjust for level front to back